OSMC stop working on DVB-T

Help and Support Vero 4K / Vero 4K +
1

I’m using Vero4k+ with 2 USB DVB-T2 tuner for 2+ years - 1st in USB port direct, 2nd in powered USB hub.
Today the Vero is in freeze state. → reboot wia power plug, while the tuner gets ready → freeze again.
Every restart with USB DVB-T dongle with antena ends in freeze. Any combination of USB input.

When I start Vero without USB DVB-T, it’s OK, but while I plug DVB-T - it depends. Without antenna - it’s working, with antenna - freezes.

I’m able to run Vero with USB DVB-T, connect antenna, than any try to run any DVB-T2 program ends with freeze.

The freeze screen looks like very dark screen. Just only dark screen. No remote keys working, no ethernet, no SSH, … nothing. Just power unplug and reboot.

Tried to make some logs:
osmc@osmc:~$ sudo journalctl -k -b 0 --no-pager|paste-log
https://paste.osmc.tv/egihixafay
osmc@osmc:~$ sudo journalctl -b 0 --no-pager|paste-log
https://paste.osmc.tv/ohofidefaf
osmc@osmc:~$
osmc@osmc:~$ sudo journalctl -k -b -1 --no-pager|paste-log
https://paste.osmc.tv/ububenexur
osmc@osmc:~$ sudo journalctl -b -1 --no-pager|paste-log
https://paste.osmc.tv/gopalimowu
osmc@osmc:~$
osmc@osmc:~$ sudo journalctl -k -b -2 --no-pager|paste-log
https://paste.osmc.tv/eyupijepev
osmc@osmc:~$ sudo journalctl -b -2 --no-pager|paste-log
https://paste.osmc.tv/equsuwilux
osmc@osmc:~$
osmc@osmc:~$ sudo journalctl -k -b -3 --no-pager|paste-log
https://paste.osmc.tv/jofuxazuxi
osmc@osmc:~$ sudo journalctl -b -3 --no-pager|paste-log
https://paste.osmc.tv/ozolitapaf

2

Hi,

I suspect that unplugging the directly connected tuner will resolve the issue. Can you confirm if this is the case?

Sam

3

No. This does not help.

When I connect USB tuner to any port (direct or wia powered hub) the Vero freeze in few minutes. The freeze is dark screen - no SSH available. After restart with USB Tuner - sometimes run to first tuned program, then freezes. Mostly the Vero freezes after the menu rises.

Now I have Orange PI 3 with 2 direct USB Tuner (no need powered USB). There is running raspbian with TVHeadend. The OPI3 has bad HDMI output. So it runs only the TVHeadend.

On Vero I set the TVHeadend Client to IP address of OPI3. It works, but it’s wrong solution.

Maybe I can try to make clean instalation. But how?

4